Works really well, wish I had found this first
ESP8266-EVB is small 57×50 mm board with Relay and Button which are connected to Internet via ESP8266 WIFI module.
ESP8266 has inside Xtensa106 processor and RF front end circuit, you do not need separate processor to drive the relay and read the button as ESP8266 can be programmed with custom code.
Here we will explain how to setup your tools and make your first project.
First you need to install your tools. It’s simple, just follow the instructions here: https://github.com/esp8266/esp8266-wiki/wiki/Toolchain
There are just few small mistakes as some commands will require SUDO before them and some paths are not exactly same, but you have to follow the steps and once you get error to read and correct the problem.
Here is what we do on Ubuntu 14.04 LTE 64-bit:
sudo apt-get install git autoconf build-essential gperf bison flex texinfo libtool libncurses5-dev wget gawk libc6-dev-amd64 python-serial libexpat-dev sudo mkdir /opt/Espressif sudo chown…
View original post 566 more words
OOmblik 